#1. Activation Instructions

Activation Code(s) for 2001 Buick Regal:

511

1. Press the FUNCTION I and PANIC buttons at the same time. Release when the STATUS LIGHT stays illuminated steady indicating you have entered ACTIVATION MODE.


2. Enter your three digit ACTIVATION CODE within 15 seconds.

  • Use the LOCK button for the first digit.
  • Use the UNLOCK button for the second digit.
  • Use the TRUNK button for the third digit.


For example: If your ACTIVATION CODE is 512, press the LOCK button 5 times, the UNLOCK button 1 time, and the TRUNK button 2 times.

3. Press the FUNCTION I and PANIC buttons at the same time. The STATUS LIGHT will turn off.

4. Watch the remote’s STATUS LIGHT. The STATUS LIGHT will flash back the ACTIVATION CODE sequence.

For example: If the ACTIVATION CODE you entered is 512, the STATUS LIGHT will emit a series of flashes matching the ACTIVATION CODE entered in Step #2.

#2. Pairing Instructions

IMPORTANT NOTES: Before entering programming mode, have in possession all of the remotes you will be using on the vehicle. Once you program the remotes, all previous codes will be erased from the memory. The other remotes will not be functional until you program the remotes again.

  1. Close the vehicle doors.
  2. Insert key in ignition and turn to ON (as far as you can without cranking engine).
  3. Turn ignition OFF, and remove the key from the ignition.
  4. Press and hold the driver side door lock switch in the UNLOCK position.
  5. Insert the ignition key into the ignition lock cylinder and remove the key. (Do not turn the ignition key in the lock cylinder.)
  6. Insert the ignition key into the ignition lock cylinder and remove the key. (Do not turn the ignition key in the lock cylinder.)
  7. Insert the ignition key into the ignition lock cylinder. (Do not turn the ignition key in the lock cylinder.) Leave the ignition key in the ignition lock cylinder.
  8. Release the door lock switch. The vehicle will sound three beeps in order to verify the Program Mode has been activated.
  9. Press the LOCK and UNLOCK buttons together on the keyless entry transmitter and hold until the vehicle beeps twice to verify that the transmitter has been successfully programmed. (This takes approximately 15 seconds.)
  10. Perform the previous step to program up to four transmitters (including your old ones).
  11. Remove the ignition key in order to exit the Program Mode.

If you're having trouble with this online manual, there is more information in our electronic copy of the print manual



Patent Pending




Sign up for our product updates mailing list: