#1. Activation Instructions

Activation Code(s) for 2001 Toyota Camry:

226

1. Press the FUNCTION I and PANIC buttons at the same time. Release when the STATUS LIGHT stays illuminated steady indicating you have entered ACTIVATION MODE.


2. Enter your three digit ACTIVATION CODE within 15 seconds.

  • Use the LOCK button for the first digit.
  • Use the UNLOCK button for the second digit.
  • Use the TRUNK button for the third digit.


For example: If your ACTIVATION CODE is 512, press the LOCK button 5 times, the UNLOCK button 1 time, and the TRUNK button 2 times.

3. Press the FUNCTION I and PANIC buttons at the same time. The STATUS LIGHT will turn off.

4. Watch the remote’s STATUS LIGHT. The STATUS LIGHT will flash back the ACTIVATION CODE sequence.

For example: If the ACTIVATION CODE you entered is 512, the STATUS LIGHT will emit a series of flashes matching the ACTIVATION CODE entered in Step #2.

#2. Pairing Instructions

  1. Start with key out of ignition, and the driver's door is open. All others are closed, and the driver's door is unlocked.
  2. Insert key into the ignition (Do NOT Turn), and pull key out.
  3. Perform these steps within 40 seconds.
    1. Using the power lock switch on the driver's door, perform 5 lock/unlock cycles starting with lock. Use an even pace, and try to go about

one cycle per second. (1 Cycle = 1 lock and 1 unlock).

  1. Close, then open driver's door.
  2. Perform these steps within 40 seconds.
    1. Using the power lock switch on the driver's door, perform 5 lock/unlock cycles starting with lock. Use an even pace, and try to go about

one cycle per second. (1 Cycle = 1 lock and 1 unlock).

  1. Insert the key in the ignition cylinder.
  2. Turn the ignition to ON (Do NOT Start) then back to OFF once to program remote while retaining the original remote codes. Twice to

erase all original codes and add new remote. Three times to check how many remotes are programmed or five times to erase all original

codes.

  1. Remove the key from the ignition.
  2. Within 3 seconds the power door locks should cycle automatically indicating successful entry into programming mode. Return to step 1 if the locks do not cycle at this point.
  3. Perform these steps within 40 seconds.
    1. Press the lock and unlock buttons on the remote simultaneously for 1 second.
    2. Immediately after letting go of the lock and unlock buttons, press the lock button by itself and hold for 2 seconds. Within 3 seconds, the

door locks should cycle once indicating successful programming. If the door locks do not cycle, or cycle twice, repeat steps A and B in step 6

as your remote has not been accepted.

  1. Repeat steps A and B in step 6 for each new remote.
  2. Close driver's door.

If you're having trouble with this online manual, there is more information in our electronic copy of the print manual



Patent Pending




Sign up for our product updates mailing list: